joshevo22

iTrader: (2)

^ hahah shhhh!!! How far is English town raceway from Pittsburgh??! I'm hoping i can make the evo vs sti thing on august 16th. that would be sweet I know there's 1 sooner but i don't think ill go to that 1.

steelcityevo8

iTrader: (18)

Yeah too bad those dickheadz scheduled that race the same day as the now 18th anual DSM/EVO shootout in ohio.

Sounds like a direct attempt at attacking Buschur Racing. But the reality it just makes people choose which event they want to go to F'n stupid IMO!!!

The DSM/EVO shootout is closer for your info plus going on 18 yrs strong

joshevo22

iTrader: (2)

^ guess im going there

Canexican

iTrader: (7)

Screw you Trav, I'm super savy.

Mike01gsr

iTrader: (33)

Well got the new stainless steel clutch line in and restrictor removed. Just have to bleed it again, can't wait to try it out.

joshevo22

iTrader: (2)

How far is the DSM/Evo shootout from pittsburgh?!? hopefully i can save up enough cash by then to get a TP, FMIC, and a tune

MondoBongo

iTrader: (10)

test pipes are the tool of the devil, and they make al gore cry.

supasixfo

iTrader: (1)

anyone get good results running a defouler to clear their CEL when using a test pipe

LostSolVTEC

iTrader: (3)

let me know if you need a hand, I'm good at spilling the fluid on your floor

LostSolVTEC

iTrader: (3)

been running one for over a year with my Buschur exhaust and never get a cel

MondoBongo

iTrader: (10)

you can just get the tephra patches on your ecu, works just as well.

dennyt4

iTrader: (43)

Blouch is a little weird...they seem to post numbers based on engine HP. They also seem to go by lb/min - so if a particular wheel flows 44 lbs./min they will say it is good for 440 HP - but again, they seem to be rating it at the engine.

I am looking at a couple of their turbos, like the Dom 3 or the 20G, and for the Dom 3 even though they say 520 HP it states "Chassis dyno results repeatedly indicate 400+ wheel horsepower and torque easily attainable with the Dominator 3.0R and supporting mods"

I would say on Buschur's dyno Arbo is doing well.



Wish I could have made it to check out the seats Damn fridge/stove delivery. Plus the guy picked up the 2G engine tranny - he is supposedly going to be using it in his car and will be on Pinks. He said it will be filmed in June or July (I forget already - damn old age)

Evol.ved

iTrader: (10)

yes.

travman

iTrader: (26)

It wasn't you.......on the forum, NOT someone local

travman

iTrader: (26)

They will probably work for you on e85 but down the road depending on your path might need upgraded again....

On FIC 1050's I was around 78% IDC on e85
(I want to note that they are labeled 1050's but my set came with a sheet showing they were flow tested to be 1080's)

http://www.fuelinjectorclinic.com/in...cal/faq.html#8