Anarchy99s First Build Thread: 2.4 Long Rod w/ Foward Facing HTA 3794 (Tons of Pics)
#81
Evolved Member
Thread Starter
iTrader: (196)
Join Date: Aug 2005
Location: Orlando/ Kissimmee
Posts: 1,196
Likes: 0
Received 0 Likes
on
0 Posts
What has happened piston wise is Manley wants to sell us their off the shelf piston they do not want to custom make it to my block and my measurements. Which is fine for anyone who has not already machined their block. They have always really only been known as an off the shelf company and so they want to just send us new rings and be done with it. So I will just end up selling the pistons to someone doing a 4G64 build that has not already machined the block or whatever. They are great pistons just not for my project.
At the PRI conference in Orlando a couple weeks back we went and had a conference with JE and they are going to make a one-off custom asymetrical piston. Should be the first evo running them I believe or at least the first 4G64 out there with them according to JE. 2-3 weeks to build so I will keep the thread updated.
#87
Evolved Member
Thread Starter
iTrader: (196)
Join Date: Aug 2005
Location: Orlando/ Kissimmee
Posts: 1,196
Likes: 0
Received 0 Likes
on
0 Posts
It has been said they can rust and whatnot but that is if you handle them and do not prepare them properly for install. These were cleaned, well oiled and then installed with gloves. There is no certainty that someone from ARP has not handled them w/out gloves so they should always be properly prepared.
#89
Evolving Member
iTrader: (56)
Join Date: Jun 2009
Location: Florida 34609
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
I just want to say thank you for sharing the build in detail. There were a few questions asked earlier but were never answered.... What piston to wall clearance are you going with and what kind of bearing clearances are you running? Is the head ported any? Thanks for your time!