EVOLUTION VIII - 2.3 Stroker Project
#32
Newbie
Join Date: Jan 2015
Location: Dominican Republic
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Remember you need to balance the crankshaft with the pulley and the clutch kit installed(except the disc) in order to get the true 0.0x rotational balance.
Even if you are using a self adjusting silicone or gel based pulley you should balance it!
don´t leave that out in this beautiful build!
Even if you are using a self adjusting silicone or gel based pulley you should balance it!
don´t leave that out in this beautiful build!
#33
Evolved Member
iTrader: (4)
Join Date: Aug 2006
Location: FLA-HI-SoCal
Posts: 1,466
Likes: 0
Received 0 Likes
on
0 Posts
Another belt you need to replace if you haven't yet, is your balance belt... I've had mine let go during a track session right at full WOT and destroyed my intake valves, Cosworth intake cam, and pistons
#35
EvoM Community Team
iTrader: (15)
Great looking headwork and attention to detail overall!
No big worries if the accessory belt breaks other than a tow. If you don't notice it you could overheat the car, but that would be pretty difficult to not notice with no power steering / ac / power loss from the alternator / etc.
No big worries if the accessory belt breaks other than a tow. If you don't notice it you could overheat the car, but that would be pretty difficult to not notice with no power steering / ac / power loss from the alternator / etc.
#37
Evolved Member
Great looking headwork and attention to detail overall!
No big worries if the accessory belt breaks other than a tow. If you don't notice it you could overheat the car, but that would be pretty difficult to not notice with no power steering / ac / power loss from the alternator / etc.
No big worries if the accessory belt breaks other than a tow. If you don't notice it you could overheat the car, but that would be pretty difficult to not notice with no power steering / ac / power loss from the alternator / etc.
#39
Evolving Member
Thread Starter
Remember you need to balance the crankshaft with the pulley and the clutch kit installed(except the disc) in order to get the true 0.0x rotational balance.
Even if you are using a self adjusting silicone or gel based pulley you should balance it!
don´t leave that out in this beautiful build!
Even if you are using a self adjusting silicone or gel based pulley you should balance it!
don´t leave that out in this beautiful build!
Another possibility will be to connect it to catch can and then to the turbo.
Will test when done the swap
Thanks, new package is on the way
Last edited by Kevin Troy; Jun 16, 2015 at 02:39 PM.