Hey guys, it's time for me to sell my baby and move on. This car has been a real joy to my life, but now its time for me to re prioritize my life. The car has never seen the track, and has never been launched. All the mods except for the engine have less than 500 miles on them. The engine itself has about 3k miles on it. It was broken in for the first 1000 miles per Jackson Auto Machine specs. The car is in storage for the winter, and does not see snow. The car made 703hp/517tq to the wheels at 40psi on DB's low reading dyno. Their are two maps, one for just C16, and one other for C16 using nitrous to spool up. Pictures and dyno sheets will be added shortly. Once, again I'd like this car to see a good home, but I am not desperate so lowballing won't get you far. I'll take offers, but if you dont have atleast 50k to spend this is not the car for you. This car is track ready, and has not been abused! Thanks for your time!

I will not part the car out.


1.JAM~2.3 EVO Stage III Shortblock, +950whp
This is our complete JAM-Stage III 2.3 EVO shortblock package, +950whp capable. Our performance package comes with all of the following brand new "In-House" custom-designed components and precision machine services applied to your Evolution series engine block:
*We remove the block oilers, balance shaft brgs, galley plug and freeze plugs
*Your empty block is completely degreased
*Main bolt holes are bottom tapped
*Line bore specs are checked w/ARP main studs
*Deck surface is precision machined to RA40 finish or better
*The deck holes are bottom tapped for ARP head studs
*The cylinders are bored over size
*Cylinders are 4 step torque plate honed w/ARP studs
*Machine the block for stroker clearances
*File fit piston rings per cylinder
*The block is then thoroughly final washed
*The new rods & pistons are then pinfit
*Install the cleaned block oilers
*Install perf coated balance shaft brgs
*Install freeze plugs, galley plug, head to block dowels
*Clean, polish and mike balance shafts
*The shortblock is then assembled
*All of these quality components are included in your complete shortblock package
*ARP main studs
*Brand new! 2.4 Forged Steel Crankshaft
*JAM-Venolia "Hard-Tuff" coated forged pistons, 85.5mm -8.5-1 cr
*New designed & 15% stronger!Oliver billet rods
*JAM~Ultra file-fit ring package
*ACL-JAM performance coated bearings
*ARP main stud kit
*Balanced as a complete-rotating assembly
Our designed and built complete shortblock package will offer you continuous perormance and value far above the rest!
*Order yours today!
2.JAM~4G63 Cylinder Head I Package

JAM~ 4g63 Cylinder Head Package I comes complete with all of the following parts and services performed to your cylinder head:
*all parts are degreased and inspected
*oil galley plugs are removed
*cylinder head is pressure tested
*solid bronze performance guides are installed
*competition multi- angle valve job
*stainless steel-swirl polished performance valves
*deck surface precision milled
*JAM~Upgraded Valve springs
*JAM~Titanium Retainers
*JAM~Premium Valve Guide seals
*You cannot not get this much for less any where!
**Option:Port and polish work for only $400.00 more!
*Core required
*Call to order yours today!
3.Brand new Shortblock and Head from JAM
4.ETS 74mm turbo kit
5.ETS 3.5in turboback exhaust
6.Buschur COP ignition
7.ETS licp piping
8.AMS Racing FMIC w/ Licp
9.DB performance custom fuel set up(dual pump housing/dual pumps/lines/fuel rails/fuel injectors)
10.Full Blown twin fuel pump set up
11.Tial BOV
12.Tial 50mm Wastegate
13.Tilton Carbon triple clutch
14.Twin Walbro Fuel Pumps
15.AEM EMS
16.AMS EVO VII/VIII/IX Twin Rail VSR Intake Manifold
17.4 1000cc injectors
18.4 1600cc injectors
19.Braille Lightweight Battery
20.STRI Boost up to 52psi/oil temp/oil pressure gauges
21.AEM UEGO Wideband
22.Vishnu spec Ohlin Coilovers
23.Girodisc front and rear 2 piece rotors
24.Ferodo 2500 brake pads
25.18X8.5 Volk wheels
26.265/35/18 Advan Neova
27.Evo 9 rear bumper
28.Cwest front bumper
29.Ings Sideskirts
30.Robi spec carbon fiber hood
31.Front and rear CV shafts from the driveshaftshop stage 5
32.Shep Ultimate evo Transmission converted to 5 speed
33.Shep stage 3 TC
34.JDM rear taillights
35.Jun 272 cams
36.Works short shifter kit
37.A spec titanium shift knob
38.Front and Rear fenders have been rolled
39.ETS solid front motor mount
40.AEM peak and holder injection driver box 10 channel
41.NX nitrous kit EFI stg 1
42.NX Gen-X-2 Accessory kit
43.Extra NX bottle
44.BBK75mm throttle body
45.BBK throttle body adapter wheel for evo
46.Fuel pressure gauge 0-100 psi
47.Aeromotive EFI adjustable FPR
48.Aeromotive fuel rails
49.ARP wheel studs
50.Samco hose kit
51.Brand new oil/oil filter/tranny fluid/tc fluid
52.Compustar 900fm security auto start
53.Alpine headunit/alpine speakers







The picture of the car on the trailer is on its way to HIN Minneapolis!



Thank you,
Greg

 

Damnnn...beautiful whip...good luck!

 

Thanks!

 

B...E...A... utiful

good luck with the sale

 

bump!

 

One day...I have to settle for my crappy 300hp dent ridden DD, lol.

Absolutely sick Evo-just goes to show what you can do with no expense spared!

Free bump for you

 

Little history on it. I am the first and only owner. Car was bought brand new with 8 miles on it in March of 05. The car has 15000 miles on the chasis.

 

bump!

 

bump!

 

bump!

 

bump!!

 

bump! some ones gotta be interested!

 

bump!!

 

bump!!

 

bump! some one must want this!