Mark this thread as Unsold
FS/FT:(TX) EvoLeo's GG Evolution IX -Must See-
#1
Newbie
Thread Starter
iTrader: (5)
Join Date: May 2010
Location: Dallas
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
FS:(TX) GG Evolution IX- Built motor//new clutch
Up for sale:
2006 Evolution IX GSR
Vin
JA3AH86C46U047710
Price: $20,000 FIRM. This car has been up for sale for sometime now and I figure I'd drop the price to get it sold quicker. Come on all you lurkers and buy this!
Brand new Clutch installed the week before christmas
I will entertain trades for similar amount plus cash on your side.
RX7s RX8s 350z basically anything sporty with RWD No trucks please
I am willing to meet close to TX, otherwise you can pick it up or arrange shipping.
I'd really like to sell to help pay for my final flight lessons.
Clear title, I am the 2nd owner. I bought this in '07 w only 4,500 miles on it.
Still have the carfax from when I bought it, but feel free to buy an update.
Originally from CA and then registered in TX when I moved here.
Current registration and tags
Please read this thread thoroughly before asking any wild questions.
93,xxx Miles on chassis and motor was built at 59,xxx
Motor
Built 2.0 MAPerformance shortblock
w/ Wisco pistons and Manley rods
ARP fasteners
ACL Race Series Main and Rod Bearings
Stock crank
Front Case w/ balance shaft eliminator
9:1:1 CR
Head
Supertech:
-Seats, seals
-Intake & inconel exhuast vavles
-Titanium valve springs and retainers
MAP headstuds
Kelford 272 cams
Trans
ACT streetlight flywheel
ACT XDSS clutch<<< BRAND NEW and freshly broken in.
Buschur aluminum shifter base bushings/ Dash + Hood
Buschur Clutch SS braided line
Replaced Clutch master cylinder sep/11
Air/Fuel
K&N 3 in intake
Nisei: licp, uicp, street intercooler (3.7 in), small battery kit, genesis mini battery
Synapse Synchronic bov
MilSpec 65 mm throttle body
MAP rev 2 ported intake manifold w thermal coating
Omni 4 bar map sensor.
Grimmspeed boost solenoid
FIC 1050cc injectors
Spoolin up coil on plug ignition
Walbro 255 fuel pump
SSP Cam sensor sheild
Exhaust
Buschur ported exhaust manifold w/ thermal dispersant
Invidia O2 pipe
Helix dp
Buschur bullet tp and cbe JDM rear bumper fitted
Suspension
Fortune Auto 500 coilovers 9k10k Spring rates
Racing Brake open slotted rotors(2 Pc) front (1 Pc) rear and et500 brake pads
TCC powdercoated brembo calipers (Candy Purple w black Brembo stencil)
^^^powdercoated and rebult with new Brembo seals.
Goodridge braided SS lines
Rota g force 18x9+30
245/40 Yokohama s drives 300 miles on them!
Touge factory hub rings
Mutegi lug nuts(anodized purple)
Exterior
EvoDave Painted headlights, taillights and side markers
JDM bumper w/ modded crash beam
Stubby antenna
Med Tint
DDM HID 55w Lows 6000k--35w Highs 6000k
Retrofitted LED bulbs in place of incandescent bulbs
Wingless, but can reinstall if necessary.
Interior
AEM UEGO wideband
Defi Red Racer boost gauge
Apexi turbo timer
Frankenstein shift knob
Tuned by Reese- Tephra Mod V7 Speed density using fuel tank IAT
#s
93 octane 363/322 26lbs
e85 410/400 29.5lbs
Still stock turbo
I'm sure I left a few things out, but this is the quick and easy.
What follows is an unreasonable amount of pics:
Exterior
Wheel shots
Interior
****NO the CEL is not on when I drive. The key is in aux mode on the ignition.****
Engine
MASSIVE ENGINE CLEAN. SOME PARTS PICTURED HAVE BEEM SOLD
$22,000 OBO serious buyers/ inquires only<<<< NOPE $20,000 FIRM
I also have a set of Volk RE30's for sale in another thread
18x9+32 i can swap in for an extra $1200
https://www.evolutionm.net/forums/sa...tte-black.html
Price drop because of side damage. First one with 20,000 or trade totaling 20,000 gets it.
Major maintenance was completed 30k 60k 90k with oil changed every 5k.
Thanks for viewing
Previous pics of car can be found here:
https://www.evolutionm.net/forums/ev...cs-gg-sty.html
2006 Evolution IX GSR
Vin
JA3AH86C46U047710
Price: $20,000 FIRM. This car has been up for sale for sometime now and I figure I'd drop the price to get it sold quicker. Come on all you lurkers and buy this!
Brand new Clutch installed the week before christmas
I will entertain trades for similar amount plus cash on your side.
RX7s RX8s 350z basically anything sporty with RWD No trucks please
I am willing to meet close to TX, otherwise you can pick it up or arrange shipping.
I'd really like to sell to help pay for my final flight lessons.
Clear title, I am the 2nd owner. I bought this in '07 w only 4,500 miles on it.
Still have the carfax from when I bought it, but feel free to buy an update.
Originally from CA and then registered in TX when I moved here.
Current registration and tags
Please read this thread thoroughly before asking any wild questions.
93,xxx Miles on chassis and motor was built at 59,xxx
Motor
Built 2.0 MAPerformance shortblock
w/ Wisco pistons and Manley rods
ARP fasteners
ACL Race Series Main and Rod Bearings
Stock crank
Front Case w/ balance shaft eliminator
9:1:1 CR
Head
Supertech:
-Seats, seals
-Intake & inconel exhuast vavles
-Titanium valve springs and retainers
MAP headstuds
Kelford 272 cams
Trans
ACT streetlight flywheel
ACT XDSS clutch<<< BRAND NEW and freshly broken in.
Buschur aluminum shifter base bushings/ Dash + Hood
Buschur Clutch SS braided line
Replaced Clutch master cylinder sep/11
Air/Fuel
K&N 3 in intake
Nisei: licp, uicp, street intercooler (3.7 in), small battery kit, genesis mini battery
Synapse Synchronic bov
MilSpec 65 mm throttle body
MAP rev 2 ported intake manifold w thermal coating
Omni 4 bar map sensor.
Grimmspeed boost solenoid
FIC 1050cc injectors
Spoolin up coil on plug ignition
Walbro 255 fuel pump
SSP Cam sensor sheild
Exhaust
Buschur ported exhaust manifold w/ thermal dispersant
Invidia O2 pipe
Helix dp
Buschur bullet tp and cbe JDM rear bumper fitted
Suspension
Fortune Auto 500 coilovers 9k10k Spring rates
Racing Brake open slotted rotors(2 Pc) front (1 Pc) rear and et500 brake pads
TCC powdercoated brembo calipers (Candy Purple w black Brembo stencil)
^^^powdercoated and rebult with new Brembo seals.
Goodridge braided SS lines
Rota g force 18x9+30
245/40 Yokohama s drives 300 miles on them!
Touge factory hub rings
Mutegi lug nuts(anodized purple)
Exterior
EvoDave Painted headlights, taillights and side markers
JDM bumper w/ modded crash beam
Stubby antenna
Med Tint
DDM HID 55w Lows 6000k--35w Highs 6000k
Retrofitted LED bulbs in place of incandescent bulbs
Wingless, but can reinstall if necessary.
Interior
AEM UEGO wideband
Defi Red Racer boost gauge
Apexi turbo timer
Frankenstein shift knob
Tuned by Reese- Tephra Mod V7 Speed density using fuel tank IAT
#s
93 octane 363/322 26lbs
e85 410/400 29.5lbs
Still stock turbo
I'm sure I left a few things out, but this is the quick and easy.
What follows is an unreasonable amount of pics:
Exterior
Wheel shots
Interior
****NO the CEL is not on when I drive. The key is in aux mode on the ignition.****
Engine
MASSIVE ENGINE CLEAN. SOME PARTS PICTURED HAVE BEEM SOLD
$22,000 OBO serious buyers/ inquires only<<<< NOPE $20,000 FIRM
I also have a set of Volk RE30's for sale in another thread
18x9+32 i can swap in for an extra $1200
https://www.evolutionm.net/forums/sa...tte-black.html
Price drop because of side damage. First one with 20,000 or trade totaling 20,000 gets it.
Major maintenance was completed 30k 60k 90k with oil changed every 5k.
Thanks for viewing
Previous pics of car can be found here:
https://www.evolutionm.net/forums/ev...cs-gg-sty.html
Last edited by EvoLeoIX; Jan 25, 2012 at 07:47 PM. Reason: Price drop!!!
#2
Newbie
Thread Starter
iTrader: (5)
Join Date: May 2010
Location: Dallas
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Fresh drivetrain fluids and spark plugs changed this week. Tires were bought about a month ago!
This is a smooth drive with speed density compared to the stock MAF. You can change between pump and e85 on the go too. No laptop MAP switching.
There are already a handful of offers thanks for the interest. Feel free to ask questions.
This is a smooth drive with speed density compared to the stock MAF. You can change between pump and e85 on the go too. No laptop MAP switching.
There are already a handful of offers thanks for the interest. Feel free to ask questions.
Last edited by EvoLeoIX; Nov 11, 2011 at 12:41 PM.
Trending Topics
#11
Newbie
Thread Starter
iTrader: (5)
Join Date: May 2010
Location: Dallas
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
I keep getting these PM's about the shifter. So here goes:
It's a custom shifter made by a company formerly based in Austin. For the most part they are pricey, but I'm really happy with this one.
www.Hotrodshiftknob.com
http://prostores3.carrierzone.com/se...com/StoreFront
I'm debating on including the Frankenstein shift knob with the car. I've grown attached to the little guy.
It's a custom shifter made by a company formerly based in Austin. For the most part they are pricey, but I'm really happy with this one.
www.Hotrodshiftknob.com
http://prostores3.carrierzone.com/se...com/StoreFront
I'm debating on including the Frankenstein shift knob with the car. I've grown attached to the little guy.
#14
Newbie
Thread Starter
iTrader: (5)
Join Date: May 2010
Location: Dallas
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
The Evo is going in for it's 90k at the beginning of next week. If you buy before then I'll throw in the service kit along with the car. Keep the offers coming. Thanks for all the praise guys.