Mark this thread as Unsold
FS[West]: 2.4 Evo 8 (Chandler, AZ)
#1
Newbie
Thread Starter
Join Date: Dec 2012
Location: AZ-chandler
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
2.4 Evo 8 (Chandler, AZ)
2003 Mitsubishi Lancer evolution
Selling my 2.4L BB Fp black Evo 8, Car has been fully built from motor to transmission. Chassis has 175k and roughly 2,500 miles on the build.
The car is sitting on ES3's wrapped in 265/35/18 RE760's which have very low miles as well. inside the car is pretty stock other than the 3 gauges
AEM wideband
Prosport oil pressure
40psi prosport digital boost gauge
Motor:
2.4L block and 100mm crank
- 2.4LR rated 1000hp internals
- (Wiseco 87mm 10.5:1 HD pistons and Oliver Heavy Duty 156mm I-beam rods, ACL Race rods, mains, and thrust bearings, ARP main studs)
- 2.4L water pump adapter plate
- Balance shaft delete
- ARP main studs
- FIC1450
- New spark plugs Iridium 8's
- FPblack BB turbo kit
- FMIC with upper IC pipe SD and Greddy Type RZ BOV and LICP
- Exedy Twin disks HD
- GSC S2 Cams
Transmission parts and labor:
- aftermarket bearing upgrade
Parts: Cylinder Head
- Valve job
- Mill, deck, wash, regrind valves, new valve seals
- Exhaust valve seats were all cracked
- Mild port and polish job
Fuel System:
- Wingz Double pumper setup
All work and tuning has been done at WingzPreformance. Asking 17k OBO, Open to trades as well. Send me message and I'll do my best to get back in contact with you
Selling my 2.4L BB Fp black Evo 8, Car has been fully built from motor to transmission. Chassis has 175k and roughly 2,500 miles on the build.
The car is sitting on ES3's wrapped in 265/35/18 RE760's which have very low miles as well. inside the car is pretty stock other than the 3 gauges
AEM wideband
Prosport oil pressure
40psi prosport digital boost gauge
Motor:
2.4L block and 100mm crank
- 2.4LR rated 1000hp internals
- (Wiseco 87mm 10.5:1 HD pistons and Oliver Heavy Duty 156mm I-beam rods, ACL Race rods, mains, and thrust bearings, ARP main studs)
- 2.4L water pump adapter plate
- Balance shaft delete
- ARP main studs
- FIC1450
- New spark plugs Iridium 8's
- FPblack BB turbo kit
- FMIC with upper IC pipe SD and Greddy Type RZ BOV and LICP
- Exedy Twin disks HD
- GSC S2 Cams
Transmission parts and labor:
- aftermarket bearing upgrade
Parts: Cylinder Head
- Valve job
- Mill, deck, wash, regrind valves, new valve seals
- Exhaust valve seats were all cracked
- Mild port and polish job
Fuel System:
- Wingz Double pumper setup
All work and tuning has been done at WingzPreformance. Asking 17k OBO, Open to trades as well. Send me message and I'll do my best to get back in contact with you
Thread
Thread Starter
Forum
Replies
Last Post
talon95gsx
West Region
1
Oct 25, 2009 11:00 PM