Mark this thread as Unsold
StopTech ST40 355mm front and ST22 Rear BBK
May 18, 2013, 06:30 PM
#1
StopTech ST40 355mm front and ST22 Rear BBK
This is a complete StopTech kit for the front and rear of the evo. The front utilizes the 355x32 rotor and the ST-40 caliper. It currently has Hawk HP+ pads for street/autox use. I have a set of used CL RC6 pads that were used for track duty. The rear is the 328x28 rotor and ST-22 caliper. It currently has Hawk HP+ for street/autox use, and I have a set of used Hawk DTC10 pads for track duty.
This setup came on the car when I purchased it. I'm not sure when they went on the car, but I currently only have 29k miles on the car. The previous owner tracked the car (I have not used the track pads). It's primary role now is cone dodging. Everything functions perfectly, but cosmetically shows it has been used for it's purpose. The finish is a little faded and there are some marks as shown in the pictures below.
These brakes work VERY well, but they are overkill for an autox only car. I'm switching back to an upgraded stock setup this week, so these will be off the car and ready to ship in a few days.
I'm located in the Wilmington, DE area. I am willing to ship. Asking for $2,000 plus shipping or best offer. Paypal is preferred (or cash if you pick up).
All pictures here: http://s800.photobucket.com/user/psu...ary/For%20Sale
This setup came on the car when I purchased it. I'm not sure when they went on the car, but I currently only have 29k miles on the car. The previous owner tracked the car (I have not used the track pads). It's primary role now is cone dodging. Everything functions perfectly, but cosmetically shows it has been used for it's purpose. The finish is a little faded and there are some marks as shown in the pictures below.
These brakes work VERY well, but they are overkill for an autox only car. I'm switching back to an upgraded stock setup this week, so these will be off the car and ready to ship in a few days.
I'm located in the Wilmington, DE area. I am willing to ship. Asking for $2,000 plus shipping or best offer. Paypal is preferred (or cash if you pick up).
All pictures here: http://s800.photobucket.com/user/psu...ary/For%20Sale
Last edited by psushoe; Oct 15, 2013 at 03:44 PM.
Trending Topics
Jun 16, 2013, 05:22 PM
#9
Some measurements on the rotors before they were boxed up:
Front Rotors 31.25mm (new is 32mm, minimum is 30mm, so more than half wear left).
Rear Rotors 27.25mm and 27.5mm (new is 28mm, minimum is 26mm, so more than half wear left).
Front Rotors 31.25mm (new is 32mm, minimum is 30mm, so more than half wear left).
Rear Rotors 27.25mm and 27.5mm (new is 28mm, minimum is 26mm, so more than half wear left).
