Mark this thread as Unsold
FS: custom 3" TBE, all stainless steel
#1
FS: custom 3" TBE, all stainless steel
this exhaust came with the car when i bought i 2 years ago. i took it off last year when i got a different exhaust. i'm not sure which shop made it but it's very well made. the flange, hanger, pipe and tip are all stain less steel and TIG weld. also an O2 bung on the down pipe for a wideband. it's 3" from front to back with no taper. this exhaust is a one piece as you can see in the picture. the muffler is in the center where the oem cat would sit. it has a flex pipe on the down pipe, so you don't have to use the oem donut gasket. it also has a 3" high flow Random Tech cat. this exhaust will not clear the front lower brace without spacers. i got a different exhaust because i like the look of a canister in the back. this exhaust give you a lot of room in the back for a rear diffuser. it's also very easy to install, it takes me less than half the time to install a 3 piece TBE.
i'm looking to get $150 for it. i'll take a partial trade for a jdm mr dv or a ix dv. as you can see, it's too large to ship so it's pickup only. i'm willing to drive 40 miles to meet or deliver this exhaust.
i didn't take to many pictures of it when it was on the car, these are the only picture i have of it on the car.
SOLD !!!
i'm looking to get $150 for it. i'll take a partial trade for a jdm mr dv or a ix dv. as you can see, it's too large to ship so it's pickup only. i'm willing to drive 40 miles to meet or deliver this exhaust.
i didn't take to many pictures of it when it was on the car, these are the only picture i have of it on the car.
SOLD !!!
Last edited by honda-guy; Sep 21, 2006 at 07:32 PM.