Mark this thread as Unsold
FS: Exedy Twin Disc
FS: Exedy Twin Disc
May 4, 2007, 07:23 AM
#3
Evolving Member
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Atlanta, Ga
Posts: 351
Likes: 0
Received 0 Likes
on
0 Posts
to be honest with u I'm not sure. On the front of the pressure plate the numbers are "3K06" and on the back of the flywheel the numbers are "3K022507S0" if that helps any......
Trending Topics
May 6, 2007, 04:53 AM
#10
Evolving Member
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Atlanta, Ga
Posts: 351
Likes: 0
Received 0 Likes
on
0 Posts
I wouldn't doubt it....... 
I know he did drag race his car a good bit too so.... There's no doubt. I spoke with this company down here called Clutch Exchange awhile back cause I was going to buy it from him and they said that all the surfaces could be resurfaced.
Only reason I'm not buying it cause I had to get a lawyer for a couple of tickets that I got in my Evo........
Money for lawyer and fines = me broke
I know he did drag race his car a good bit too so.... There's no doubt. I spoke with this company down here called Clutch Exchange awhile back cause I was going to buy it from him and they said that all the surfaces could be resurfaced. Only reason I'm not buying it cause I had to get a lawyer for a couple of tickets that I got in my Evo........
Money for lawyer and fines = me broke
May 6, 2007, 05:13 AM
#12
Evolving Member
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Atlanta, Ga
Posts: 351
Likes: 0
Received 0 Likes
on
0 Posts
I'll measure tonite when I get home from work and post the specs. I don't think it's worn too bad. There's no grooves in any of the surfaces.
May 7, 2007, 08:20 PM
#15
Evolving Member
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Atlanta, Ga
Posts: 351
Likes: 0
Received 0 Likes
on
0 Posts
I measured what I could.
1st disc - 0.14mm
Middle Idler - 15.61mm
2nd disc - 0.14mm
There's really no way to measure the first idler or flywheel. The surfaces do not have deep grooves in them at all. There's some grooves but not bad. I was told by the guy at Clutch Exchange he could resurface all of the surfaces and it would be fine.
1st disc - 0.14mm
Middle Idler - 15.61mm
2nd disc - 0.14mm
There's really no way to measure the first idler or flywheel. The surfaces do not have deep grooves in them at all. There's some grooves but not bad. I was told by the guy at Clutch Exchange he could resurface all of the surfaces and it would be fine.