Mark this thread as Unsold
FS: Exedy Twin Disc
#3
Evolving Member
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Atlanta, Ga
Posts: 351
Likes: 0
Received 0 Likes
on
0 Posts
to be honest with u I'm not sure. On the front of the pressure plate the numbers are "3K06" and on the back of the flywheel the numbers are "3K022507S0" if that helps any......
Trending Topics
#10
Evolving Member
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Atlanta, Ga
Posts: 351
Likes: 0
Received 0 Likes
on
0 Posts
I wouldn't doubt it....... I know he did drag race his car a good bit too so.... There's no doubt. I spoke with this company down here called Clutch Exchange awhile back cause I was going to buy it from him and they said that all the surfaces could be resurfaced.
Only reason I'm not buying it cause I had to get a lawyer for a couple of tickets that I got in my Evo........
Money for lawyer and fines = me broke
Only reason I'm not buying it cause I had to get a lawyer for a couple of tickets that I got in my Evo........
Money for lawyer and fines = me broke
#15
Evolving Member
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Atlanta, Ga
Posts: 351
Likes: 0
Received 0 Likes
on
0 Posts
I measured what I could.
1st disc - 0.14mm
Middle Idler - 15.61mm
2nd disc - 0.14mm
There's really no way to measure the first idler or flywheel. The surfaces do not have deep grooves in them at all. There's some grooves but not bad. I was told by the guy at Clutch Exchange he could resurface all of the surfaces and it would be fine.
1st disc - 0.14mm
Middle Idler - 15.61mm
2nd disc - 0.14mm
There's really no way to measure the first idler or flywheel. The surfaces do not have deep grooves in them at all. There's some grooves but not bad. I was told by the guy at Clutch Exchange he could resurface all of the surfaces and it would be fine.