I'm changing up my current setup.

For sale: Map Rev 3 ported intake manifold, that has been sent to Curt Brown Racing and had an Extreme port job with a 70mm flange welded on as well! Yes, that is correct this manifold as been ported twice. Curt went through the whole IM and cleaned up alot of imperfections in the previous port work. I'm not downing the REV 3,I ran multiple 10 sec passes on an fp green with this manifold!
but I wanted perfect this time around I did not lose any down low power at all. And made over 800whp with this manifold. This is a direct bolt on. I'd like to say a stock ported tb will work, but i do not believe that will optimize the manifold. Recommended a S90 or boomba.

PCV tube on side removed and welded shut to avoid any leaks.
EGR block off included( I cant remember what brand I purchased)


All prices are plus pp fees + shipping $OLD

 

You could send your stock manifold to him and get the port work done for $300

Good luck

 

I'm aware of that. But this is a very extensive port job, I don't believe curt will port any manifold to the to this extent for the same price. Many many more hours are put into this port job.

 

up up!

 

I know you're trying to recoupe some money from paying to have this ported twice, but you can buy the "best" CBRE porting for $300 per his website. $600 is quite unreasonable..


70mm extreme port for Evo 8/9, starts with a 70mm flange welded on to allow for any 68-70mm aftermarket throttle body to be used, this enables a full 70 mm throughout the plenum, this is the best performing manifold for 850whp and under Evo's out there, 50ft lbs of tq over the second best manifold(skunk2) with no loss in top end. All 70mm jobs now come with free Curt Brown Racing red EGR block off plate!$300

 

Shoot me an offer buddy, I'm not trying to take anyones lunch money. I have proven this manifold works very well.
This is not classified as a standard port job by CBRE,

 

bumpy obo

 

bUMPYYYY

 

Obo

 

Ttt

 

Sold!