Mark this thread as Unsold
FS[West]: FS: AEM v.1 ECU - recently bench tested and updated by AEM
Oct 28, 2016, 07:06 PM
#5
As I mentioned, it has been fully bench tested by AEM to be working properly in all respects, and it has been upgraded with a v.2 ignition driver board by AEM. I feel very confident in telling anyone that it is fully operational and works like it should. I can provide the buyer with the email confirmations of testing results and upgrade done from AEM. This is as good as it gets for a v.1 AEM unit. I agree that I'm selling at a reasonable price, which is in order to recoup some funds sooner rather than later to reduce the price I paid for the Haltech Elite and some upgrades to support it.
I will leave the .cal file in it that was the last iteration that I used, but I do not guarantee that the .cal file will work on your car, since your setup will be likely quite different than mine. Good practice is to clear the .cal file that's in the ECU and replace it with one that is specifically designed for YOUR car by YOUR tuner.
Let me know if you would like it.
I will leave the .cal file in it that was the last iteration that I used, but I do not guarantee that the .cal file will work on your car, since your setup will be likely quite different than mine. Good practice is to clear the .cal file that's in the ECU and replace it with one that is specifically designed for YOUR car by YOUR tuner.
Let me know if you would like it.
Thread
Thread Starter
Forum
Replies
Last Post
Koroshiya
Evo X Engine Management / Tuning Forums
20
Oct 20, 2015 07:54 PM
