Boost_Inspired

iTrader: (37)

found out the problem to both issues. Boost controller I had a boost leak down on the wastegate line , it wasn't tight enough so I had to buy slightly smaller line so now on the lowest setting it hits 24psi then tapers to about 22. So its safe to say I'm not gettin on it anymore until july 10th lol. Also one wire on my o2 sensor broke so I'm gonna attempt to solder it tomorrow after work and heat shrink around the wire and see if it works. If not I'll buy a new sensor and route it a little differently.

Frontskill

The cruise was fun

Boost_Inspired

iTrader: (37)

Is it every week? Damn I wouldve went if I wasn't working on the evo

monkey_187

iTrader: (16)

Where did you guys go and what did you do after?

Frontskill

Not sure the exact route, it was local. Backroads around 195,183,2481(?). It was cool. I didn't stay for the after but I think they went to go eat or bar b Q.

Boost_Inspired

iTrader: (37)

woot my cams made it in today, I can't wait to get tuned.

Krazyk

iTrader: (1)

Nice, I know that feeling of waiting to get tuned all to well!!! Did u decide if your going to install the cams yourself??

Boost_Inspired

iTrader: (37)

No I'm have kevind do it, only reason y is I don't have the tools to do the valve springs myself. Did they break ur cams in or did u have to do it?

gravvyboy

Hello again all. I've been away in Afghanistan since last year and I and Super Panda are back on the streets of Texas. I've seen a few new Evos rolling around and gave the nead nod to a TB with a racing wing earlier on Trimmier near the 190. I'm asking for myself as well as a buddy. Are there any reputable paint shops over here that will shoot good paint, clearcoat, etc that will be show worthy and worth the cost invested. Looking at spending no more than $1500 and going as far as Austin to get it done. Thanks and see you out on the streets.

Boost_Inspired

iTrader: (37)

btw got my wideband fixed , had to reposition my sensor wiring and solder one wire that broke.

Krazyk

iTrader: (1)

Good to hear bro!! Kevin took care of it for me, I dont believe it takes to long to break em in.

Boost_Inspired

iTrader: (37)

ya kelford says to rev the motor between 1500-2500 for 20 mins

Krazyk

iTrader: (1)

Yeah I remember reading that now. When are you goetting them installed? Are you having Kevin tune it as well or are you waiting for your mellon tune?

Boost_Inspired

iTrader: (37)

goin this saturday to get em in and im waitin to get tuned from chris so I'll be driving around in grandpa mode

Krazyk

iTrader: (1)

Nice, yeah its not much fun driving around with the cams untuned I had to do it for two weeks.