freakin greddy for ya, remember what i said about putting washers on the spring bolts to lower it down,

 

spring bolts?? who uses those?? I haven't had those on my car in yrs...

 

All night to figure out an exhaust issue...come on buddy...Does your exhaust use the stock donut gasket or is the flange smaller and slides over the bottom of the 02 housing??

 

Thinking about hitting up some place to watch the ufc fights tonight...anyone interested in joining???

 

Ale House in Brier Creek & Hooters by the airport are both showing the fights...

 

http://www.funnyordie.co.uk/videos/5...ubulargoldmine

hahahah...

 

^HAHAHHAHAHAHAHAHA That was HILARIOUS man!

 

Guys, let me know if u know someone selling a either a stock actuator or a forge one.

 

I fixed the issue on saturday night after all. The pipe hitting the diff was causing all the ruckus. It didn't go away by just removing the two middle hangers of the exhaust but I used those rubber pieces to push the exhaust even further down and that did the trick.

Thanks Ali, Daniel, and Justin.

 

good stuff, told ya it wouldnt be a big deal. Now lets do some talking about more boost/fuel/tune

 

^^Glad you got it figured out man. Now you can enjoy it

 

As promised, here are some very low quality cell phone pics w/ the new wheels:

Before:



Wheels ready to go:



Wheels on w/out camber added to front:




Camber fixed:




On another subject, here's Robert wrenching away



And here's one just for Justin - Problem: Slammed BMW is too low to get even a scissor jack under. Solution: Some "Fail" inginuity and some old Advan boxes equals custom BMW car ramps. I spiced them up a little... nothing you can't take care of with Duck Tape!

 

LOL

that is awesome. wheels look great too man!

 

ahhhh...Did you not remove the bracket that held on the heat shield for the center driveshaft loop?? I grabbed onto that bi*ch with a big a$$ wrench and ripped it off...haha...

 

& nice job Daniel...rims look sick on ur car...so whats next??