Raleigh/Durham/Triangle Area Meet
#3212
#3213
All night to figure out an exhaust issue...come on buddy...Does your exhaust use the stock donut gasket or is the flange smaller and slides over the bottom of the 02 housing??
#3216
#3219
I fixed the issue on saturday night after all. The pipe hitting the diff was causing all the ruckus. It didn't go away by just removing the two middle hangers of the exhaust but I used those rubber pieces to push the exhaust even further down and that did the trick.
Thanks Ali, Daniel, and Justin.
Thanks Ali, Daniel, and Justin.
#3222
As promised, here are some very low quality cell phone pics w/ the new wheels:
Before:
Wheels ready to go:
Wheels on w/out camber added to front:
Camber fixed:
On another subject, here's Robert wrenching away
And here's one just for Justin - Problem: Slammed BMW is too low to get even a scissor jack under. Solution: Some "Fail" inginuity and some old Advan boxes equals custom BMW car ramps. I spiced them up a little... nothing you can't take care of with Duck Tape!
Before:
Wheels ready to go:
Wheels on w/out camber added to front:
Camber fixed:
On another subject, here's Robert wrenching away
And here's one just for Justin - Problem: Slammed BMW is too low to get even a scissor jack under. Solution: Some "Fail" inginuity and some old Advan boxes equals custom BMW car ramps. I spiced them up a little... nothing you can't take care of with Duck Tape!
#3224
I fixed the issue on saturday night after all. The pipe hitting the diff was causing all the ruckus. It didn't go away by just removing the two middle hangers of the exhaust but I used those rubber pieces to push the exhaust even further down and that did the trick.
Thanks Ali, Daniel, and Justin.
Thanks Ali, Daniel, and Justin.