The Do and Do not in a alky injection system
#31
Former Sponsor
iTrader: (5)
Join Date: Aug 2005
Location: England
Posts: 2,236
Likes: 0
Received 0 Likes
on
0 Posts
Start the WL from 6 clicks form full counter-clockwise.
Then adjust the WH from fully clockwise. Once this is done, adjust each trimmer back 1 to 2 clicks back.
Are you using the failsafe output to cut boost or switch map?
#37
Evolving Member
iTrader: (2)
Join Date: Aug 2006
Location: Texas
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
First of all, adjust your bargraph reading to about ~6 bars at full boost (SC), Then adjust the WL and WH until the "B" led lights up during the spray range.
Start the WL from 6 clicks form full counter-clockwise.
Then adjust the WH from fully clockwise. Once this is done, adjust each trimmer back 1 to 2 clicks back.
Are you using the failsafe output to cut boost or switch map?
Start the WL from 6 clicks form full counter-clockwise.
Then adjust the WH from fully clockwise. Once this is done, adjust each trimmer back 1 to 2 clicks back.
Are you using the failsafe output to cut boost or switch map?
I do have a failsafe solenoid. Will this mater when setting these adjustments?