show me your meth kit setup!!
#17
Evolving Member
Thread Starter
iTrader: (1)
Join Date: Mar 2008
Location: Taunton, MA
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
I got my tank and pump in the trunk but leaning against the back side I made brakets for it... it looks clean... when I get my car back from the dealership I'll post pics but it will not be for at least a week because they need to replace my whole transmission..
#21
Evolved Member
iTrader: (55)
The cleanest way is to put it in the trunk opposite where the stock washerfluid goes. But if you're going to go big reservoirs here's what i did(see pic below).
Took out rear seats(easy), 3 strips of aluminum 1-1/4 wide 3' long per strip(home depot) Bolts used were 1.25x8mm ...length I believe 2"'s long. Measure drill holes, dremel. Took me about 4hrs to do including soldering and running lines. I used to have my setup in the front but decided to acquire a bigger set of tanks for less refilling.
I also have the upgrade 250psi Labonte pump running 2 nozzles.
NEW SETUP:
OLD SETUP:
Took out rear seats(easy), 3 strips of aluminum 1-1/4 wide 3' long per strip(home depot) Bolts used were 1.25x8mm ...length I believe 2"'s long. Measure drill holes, dremel. Took me about 4hrs to do including soldering and running lines. I used to have my setup in the front but decided to acquire a bigger set of tanks for less refilling.
I also have the upgrade 250psi Labonte pump running 2 nozzles.
NEW SETUP:
OLD SETUP:
#27
Former Sponsor
iTrader: (6)
Join Date: Jan 2007
Location: long island
Posts: 1,840
Likes: 0
Received 0 Likes
on
0 Posts
The cleanest way is to put it in the trunk opposite where the stock washerfluid goes. But if you're going to go big reservoirs here's what i did(see pic below).
Took out rear seats(easy), 3 strips of aluminum 1-1/4 wide 3' long per strip(home depot) Bolts used were 1.25x8mm ...length I believe 2"'s long. Measure drill holes, dremel. Took me about 4hrs to do including soldering and running lines. I used to have my setup in the front but decided to acquire a bigger set of tanks for less refilling.
I also have the upgrade 250psi Labonte pump running 2 nozzles.
NEW SETUP:
OLD SETUP:
Took out rear seats(easy), 3 strips of aluminum 1-1/4 wide 3' long per strip(home depot) Bolts used were 1.25x8mm ...length I believe 2"'s long. Measure drill holes, dremel. Took me about 4hrs to do including soldering and running lines. I used to have my setup in the front but decided to acquire a bigger set of tanks for less refilling.
I also have the upgrade 250psi Labonte pump running 2 nozzles.
NEW SETUP:
OLD SETUP:
Looks great man!!!