***Official NV Chat Thread***
Feb 11, 2011, 11:14 PM
#5042
Newbie
iTrader: (2)
Join Date: Jun 2006
Location: Las Vegas
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
nope...not a bike cop. Just a very chill officer and partner. They too said "you're lucky we weren't bike cops!"
Thanks, I'll pm you later.....and noooooow I feel like a *****, it's Eddie right? I haven't been out to the meets for over 4 years now! You helped when I had that stupid snorkel suction issue
Thanks, I'll pm you later.....and noooooow I feel like a *****, it's Eddie right? I haven't been out to the meets for over 4 years now! You helped when I had that stupid snorkel suction issue
Feb 12, 2011, 11:26 AM
#5049
Evolving Member
iTrader: (14)
Join Date: May 2007
Location: Las Vegas
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
I was tearing mine apart yesterday so I couldn't make the meet....
Ok ... Replacing the Alternator is tough job... but now that I've done it, I can see that it would only take a couple hours to knock it out... I did a LOT of extra work failing to take it out another way and then having to put that all back together
I does come out the bottom of the car... remove axle... lift motor.... loosen exhaust... remove K bar (on my car).... and you will give birth to an 8 lbs. Alt....
now my light flickers at idle... sigh... maybe I should have gotten a new tensioner too
Ok ... Replacing the Alternator is tough job... but now that I've done it, I can see that it would only take a couple hours to knock it out... I did a LOT of extra work failing to take it out another way and then having to put that all back together
I does come out the bottom of the car... remove axle... lift motor.... loosen exhaust... remove K bar (on my car).... and you will give birth to an 8 lbs. Alt....
now my light flickers at idle... sigh... maybe I should have gotten a new tensioner too
who dat?
Feb 12, 2011, 01:38 PM
#5050
Newbie
iTrader: (3)
Join Date: Jul 2010
Location: Las Vegas
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Funny story guys...So I'm getting my cams installed right now. We pulled the valve cover off and guess what I see....A Tomei exhaust cam. : P Who put that there!? haha Yay for free money!
Feb 12, 2011, 03:05 PM
#5054
Newbie
iTrader: (3)
Join Date: Jul 2010
Location: Las Vegas
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
I hope so. I think Harvey said brand new those things were $800! Imma post em up for $450 or somethin.lol. Atleast it'll pay for the broken kelford I had to replace and part of the install. Good karma FTW
Feb 12, 2011, 06:39 PM
#5055
Evolving Member
iTrader: (21)
Join Date: Jan 2006
Location: LAS VEGAS
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
