***Official NV Chat Thread***
Evolving Member
iTrader: (14)
Join Date: May 2007
Location: Las Vegas
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
Evolving Member
Did not make it. My back was killing me this morning.
Cars and coffee is Saturday at 8 a.m. On Eastern and Serene.
Cars and coffee is Saturday at 8 a.m. On Eastern and Serene.
Last edited by BlueX702; Feb 9, 2013 at 08:19 PM.
Newbie
iTrader: (2)
Join Date: Jul 2008
Location: North LV
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Newbie
iTrader: (4)
Join Date: Nov 2009
Location: Vegas
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Washed my car this afternoon.... started it up to put it back in the garage. It was cold and on an incline and i stalled it.... now it will crank all day long but won't start.
wtf... any ideas?
wtf... any ideas?
Evolving Member
iTrader: (21)
Join Date: Jan 2006
Location: LAS VEGAS
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
check to see if your clutch pedal switch is making full contact with the pedal when you push it all the way down. Sometimes the bracket the switch is mounted to gets bent. just re align it and try again. or simply disconnect the 2pin harness from the back of the switch. good luck
Newbie
iTrader: (4)
Join Date: Nov 2009
Location: Vegas
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
OK found it.... there are 2 fuses under the dash with the engine symbol on them.... turns out when it stalled it popped the 10amp fuse... put a new one in and it fired right up
Last edited by MarkS; Feb 13, 2013 at 05:26 PM.
Evolving Member
iTrader: (31)
Join Date: Sep 2006
Location: Las Vegas
Posts: 299
Likes: 0
Received 0 Likes
on
0 Posts
check to see if your clutch pedal switch is making full contact with the pedal when you push it all the way down. Sometimes the bracket the switch is mounted to gets bent. just re align it and try again. or simply disconnect the 2pin harness from the back of the switch. good luck